Subaru Legacy BN/BS (2015-2019) Service Manual: Idle speed inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Mechanical(h4do) / Idle speed inspection

1. Before checking the idle speed, check the following item:

(1) Check the air cleaner element is free from clogging, ignition timing is correct, spark plugs are in good condition, and hoses are connected properly.

(2) Check the malfunction indicator light does not illuminate.

2. Warm up the engine.

3. Read the engine idle speed using Subaru Select Monitor. Subaru Select Monitor > OPERATION

NOTE:

• Idle speed cannot be adjusted manually, because the idle speed is automatically adjusted.

• If idle speed is out of standard, refer to the General Diagnosis Table under “Engine Control System”. Basic Diagnostic Procedure

(1) Check the idle speed when no-loaded. (Headlight, blower fan, rear defroster, radiator fan, A/C and etc. are OFF)

Idle speed (No load, and for CVT model, select lever in “P” or “N” range, for MT model, gear shift lever in neutral position.):

Standard

675±100 r/min (CVT model)
650±100 r/min (MT model)

(2) Check the idle speed when loaded. (Turn the A/C switch to ON and operate the compressor for at least one minute before measurement.)

Idle speed (A/C on, and for CVT model, select lever in “P” or “N” range, for MT model, gear shift lever in neutral position.):

Standard

800 — 900±100 r/min

Fuel pressure inspection

1. Release the fuel pressure. Fuel > PROCEDURE2. Open the fuel filler lid and remove the fuel filler cap.NOTE:This operation is required to release the inner pressure of the fuel tank.3. Disconnect t ...

Ignition timing inspection

CAUTION:After warming-up, engine becomes very hot. Be careful not to burn yourself at measurement.1. Before checking the ignition timing, check the following item:(1) Check the air cleaner element is ...

Other materials:

Dtc p000b "b" camshaft position slow response bank 1
NOTE:For the diagnostic procedure, refer to DTC P0014. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0014 "B" CAMSHAFT POSITION - TIMING OVER-ADVANCED OR SYSTEM PERFORMANCE BANK 11. OUTLINE OF DIAGNOSISDetect the exhaust AVCS system malfunction.Judge NG when the amount of exhaust A ...