Subaru Legacy BN/BS (2015-2019) Service Manual: Ignition timing inspection
CAUTION: After warming-up, engine becomes very hot. Be careful not to burn yourself at measurement. 1. Before checking the ignition timing, check the following item: (1) Check the air cleaner element is free from clogging, spark plugs are in good condition, and hoses are connected properly. (2) Check the malfunction indicator light does not illuminate. 2. Warm up the engine. 3. Read the ignition timing using Subaru Select Monitor. Subaru Select Monitor > OPERATION NOTE: If ignition timing is out of standard, check the ignition control system. Refer to “Engine Control System”. Basic Diagnostic Procedure Ignition timing [BTDC/{r/min}]: Standard 5°±10°/675 (CVT model) |
Idle speed inspection
1. Before checking the idle speed, check the following item:(1) Check the air cleaner element is free from clogging, ignition timing is correct, spark plugs are in good condition, and hoses are connec ...
Intake and exhaust valve specification
Refer to “Cylinder Head” for removal and installation procedures of the intake and exhaust valves. Cylinder Head > REMOVAL Cylinder Head > INSTALLATION ...
Other materials:
Removal
1. SEDAN MODEL1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the trunk trim panel - side. Trunk Room Trim > REMOVAL3. Remove the rear side marker light bulb. Rear Combination Light Assembly > DISASSEMBLY2. OUTBACK MODEL1. Disconnect the ground terminal from battery sensor. ...
