Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Mechanical(h4do) / Crank pulley / Inspection

1. Check that the crank pulley has no deformation, cracks or other damages.

2. Inspect for oil leakage from the front oil seal. If there is an oil leak, replace the front oil seal with a new one. Crank Pulley > REMOVAL

Removal

NOTE:When replacing a single part, perform the work with the engine assembly installed to body.1. When working on the vehicleNOTE:When working on the vehicle, perform the following steps also.(1) Remo ...

Installation

1. Degrease the press-fit section for the chain cover front oil seal, and install the front oil seal to the chain cover using ST.CAUTION:Do not apply fluid such as engine oil to the front oil seal and ...

Other materials:

Removal
1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE2. Remove the trim panel - rear apron LH. Rear Quarter Trim > REMOVAL3. Remove the power rear gate control module (PRG CM).(1) Disconnect the connectors in the following order.1: D ...