Subaru Legacy BN/BS (2015-2019) Service Manual: Engine mounting

Installation

1. Apply a small amount of grease to splines of main shaft. (MT model)Grease:NICHIMOLY N-130 or equivalent2. Position the engine in engine compartment and align it with transmission.NOTE:Be careful no ...

Removal

1. FRONT CUSHION RUBBER AND ENGINE MOUNTING BRACKET1. Fully open the front hood. NOTE2. Disconnect the ground terminal from battery sensor. NOTE3. Remove the air intake duct. Air Intake Duct > REMO ...

Other materials:

Dtc b1812 short in driver's airbag dual stage - 2nd step (to ground)
DIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:GND short circuit failure (shorted to ground in main harness, shorted to ground in roll connector, shorted to ground in driver’s airbag, shorted to ground in airbag CM internal circuit)CAUTION:Before performing ...