Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Power rear gate system / Power rear gate buzzer / Inspection

Refer to “Basic Diagnostic Procedure” of “POWER REAR GATE SYSTEM (DIAGNOSTICS)”. Diagnostics with Phenomenon > INSPECTION

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the trim panel - rear gate. Rear Gate Trim > REMOVAL3. Remove the power rear gate buzzer.(1) Disconnect the connector.(2) Release ...

Installation

1. Install the power rear gate buzzer.2. Install the trim panel - rear gate.3. Connect the ground terminal to battery sensor. NOTE ...

Other materials:

Dtc b1812 short in driver's airbag dual stage - 2nd step (to ground)
DIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:GND short circuit failure (shorted to ground in main harness, shorted to ground in roll connector, shorted to ground in driver’s airbag, shorted to ground in airbag CM internal circuit)CAUTION:Before performing ...