Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Power rear gate system / Power rear gate inner switch / Inspection

1. Measure the resistance between connector terminals.

Preparation tool:

Circuit tester

Terminal No.	Inspection conditions	Standard
1 — 2	Switch OFF	1 M- or more
1 — 2	Switch ON	Less than 1 -

2. Replace the power rear gate inner switch, if the inspection result is not within the standard value.

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the power rear gate inner switch.(1) Release the claws and pull out the power rear gate inner switch rearward.NOTE:Insert a flat t ...

Installation

1. Install the power rear gate inner switch.2. Connect the ground terminal to battery sensor. NOTE ...

Other materials:

Disassembly
1. TRANSFER CASE1. Remove the interlock plate.NOTE:Do not remove the precoat bolt (B) if the parts are assembled as a transmission assembly.(A)Interlock plate(B)Precoat bolt2. Remove the shift link assembly. Shift Link Assembly > REMOVAL2. EXTENSION CASE1. Remove the transfer drive gear assembly. ...