Subaru Legacy BN/BS (2015-2019) Service Manual: Power rear gate inner switch

Installation

1. Install the power rear gate driver’s switch.2. Install the cover assembly - instrument panel LWR driver.3. Connect the ground terminal to battery sensor. NOTE ...

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the power rear gate inner switch.(1) Release the claws and pull out the power rear gate inner switch rearward.NOTE:Insert a flat t ...

Other materials:

Dtc b1812 short in driver's airbag dual stage - 2nd step (to ground)
DIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:GND short circuit failure (shorted to ground in main harness, shorted to ground in roll connector, shorted to ground in driver’s airbag, shorted to ground in airbag CM internal circuit)CAUTION:Before performing ...