Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Power rear gate system / Power rear gate driver’s switch / Installation

1. Install the power rear gate driver’s switch.

2. Install the cover assembly - instrument panel LWR driver.

3. Connect the ground terminal to battery sensor. NOTE

Inspection

1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard1 — 4Switch OFF1 M- or moreSwitch ONLess than 1 -2. Apply battery voltag ...

Power rear gate inner switch

...

Other materials:

Dtc p0138 o2 sensor circuit high voltage bank 1 sensor 2
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...