Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Power rear gate system / Power rear gate driver’s switch / Inspection

1. Measure the resistance between connector terminals.

Preparation tool:

Circuit tester

Terminal No.	Inspection conditions	Standard
1 — 4	Switch OFF	1 M- or more
1 — 4	Switch ON	Less than 1 -

2. Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.

Terminal No.	Inspection conditions	Specification
2 (+) — 3 (−)	Apply battery voltage.	Light ON

3. Replace the power rear gate driver’s switch if the inspection result is not within the standard value.

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL3. Release the claws, and then remove the ...

Installation

1. Install the power rear gate driver’s switch.2. Install the cover assembly - instrument panel LWR driver.3. Connect the ground terminal to battery sensor. NOTE ...

Other materials:

Dtc p2750 intermediate shaft speed sensor "c" circuit range/performance
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Shifting shock is felt.• Acceleration is poor during standing start.• Shift control malfunction1. ENGINE TYPE FBSTEPCHECKYESNO1.CHECK DTC.Read the DTC using Subaru Select Monitor.Besides DTC P2750, is any of ...