Subaru Legacy BN/BS (2015-2019) Service Manual: Removal

Subaru Legacy BN/BS (2015-2019) Service Manual / Power rear gate system / Power rear gate driver’s switch / Removal

1. Disconnect the ground terminal from battery sensor. NOTE

2. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL

3. Release the claws, and then remove the power rear gate driver’s switch (a).

Power rear gate driver’s switch

...

Inspection

1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard1 — 4Switch OFF1 M- or moreSwitch ONLess than 1 -2. Apply battery voltag ...

Other materials:

Installation
1. Apply liquid gasket to the mating surface of cylinder block shown in the figure.NOTE:• Install within 5 min. after applying liquid gasket.• Do not apply liquid gasket excessively. If too much is applied, remove any liquid gasket that is squeezed out.Liquid gasket:THREE BOND 1217G (K08 ...