Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Vehicle dynamics control (vdc) / Relay and fuse / Inspection

1. CHECK FUSE

1. Remove the fuse and inspect visually.

2. If the fuse is blown out, replace the fuse.

2. CHECK RELAY

1. Measure the resistance between relay terminals.

Terminal No.	Inspection conditions	Standard	Circuit
1 — 2	Always	1 M- or more
1 — 4	Always	Less than 1 -
1 — 2	Apply battery voltage between terminals 3 and 5.	Less than 1 -

2. Replace the relay if the inspection result is not within the standard value.

Location

Main fuse box (M/B)Fuse 40 A(A)Fuse 30 A(B)Brake light relay(C)Fuse & relay box (F/B)Fuse 7.5 A(D)NOTE:For details concerning other fuses and relays, refer to the wiring diagram. Power Supply Circuit ...

Steering angle sensor

...

Other materials:

Note
For procedure of each component in the power rear gate system, refer to the respective section.• Power rear gate control module (PRG CM): Power Rear Gate Control Module• Power rear gate drive unit (PRG D/U): Power Rear Gate Drive Unit• Power rear gate rod: Power Rear Gate Rod&bu ...