Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Wiper and washer systems / Relay and fuse / Inspection

1. CHECK FUSE

1. Remove the fuse and inspect visually.

2. If the fuse is blown out, replace the fuse.

2. CHECK RELAY

1. Measure the resistance between relay terminals.

Terminal No.	Inspection conditions	Standard	Circuit
1 — 2	Always	1 M- or more
1 — 2	Apply battery voltage between terminals 4 and 3.	Less than 1 -

Terminal No.	Inspection conditions	Standard	Circuit
1 — 2	Always	1 M- or more
1 — 4	Always	Less than 1 -
1 — 2	Apply battery voltage between terminals 3 and 5.	Less than 1 -

2. Replace the relay if the inspection result is not within the standard value.

Location

Main fuse box (M/B)Fuse 30 A(A)Fuse 15 A(B)Relay(C)NOTE:For other related fuses, refer to the wiring diagram. Power Supply Circuit ...

Other materials:

Dtc p2530 ignition switch run position circuit
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:Faulty TCM operationWIRING DIAGRAM:• ENGINE TYPE FBCVT control system CVT Control System > WIRING DIAGRAM• ENGINE TYPE EZCVT control system CVT Control System > WIRING DIAGRAMSTEPCHECKYESNO1.CHECK CONNECTOR.Check t ...

Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Location

Washer tank and motor

Other materials: