Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Glass windows mirrors / Rear regulator and motor assembly / Inspection

1. Check the motor operation when battery voltage is applied between the connector terminals.

• LH side

Terminal No.	Inspection conditions	Standard
4 (+) — 1(−)	Apply battery voltage between terminals.	Increase
1 (+) — 4(−)	Apply battery voltage between terminals.	Decrease

• RH side

Terminal No.	Inspection conditions	Standard
3 (+) — 6(−)	Apply battery voltage between terminals.	Increase
6 (+) — 3(−)	Apply battery voltage between terminals.	Decrease

2. If it does not operate properly as a result of inspection, replace the regulator and motor assembly - rear.

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the trim panel - rear door. Door Trim > REMOVAL3. Remove the sealing cover - rear door.4. Remove the glass assembly - rear door. ...

Installation

1. Install the regulator and motor assembly rear.Tightening torque:7.5 N·m (0.8 kgf-m, 5.5 ft-lb)2. Install the glass assembly - rear door. Rear Door Glass > INSTALLATION3. Install the sealing ...

Other materials:

Seatbelt maintenance
To clean the seatbelts, use a mild soap and lukewarm water. Never bleach or dye the belts because this could seriously affect their strength. Inspect the seatbelts and attachments including the webbing and all hardware periodically for cracks, cuts, gashes, tears, damage, loose bolts or wor ...