Subaru Legacy BN/BS (2015-2019) Service Manual: Rear regulator and motor assembly

Installation

1. Fabricate the cartridge nozzle tip as shown and set the sealant gun with the adhesive.(a)10 mm (0.39 in)(b)8 mm (0.31 in)(c)Sealant gun2. Smoothen and clean the adhesive surfaces of the glass - rea ...

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the trim panel - rear door. Door Trim > REMOVAL3. Remove the sealing cover - rear door.4. Remove the glass assembly - rear door. ...

Other materials:

Shift lock release
If the select lever cannot be operated, turn the ignition switch back to the "ON" position then move the select lever to the "P" position with the select lever button pressed and brake pedal depressed. If the select lever does not move after performing the above procedure, perform the follo ...