Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Glass windows mirrors / Remote control mirror switch / Inspection

1. Check the resistance between connector terminals.

Preparation tool:

Circuit tester

• Changeover switch RH

Terminal No.	Inspection conditions	Standard
—	OFF	1 M- or more
1 — 12 9 — 7	UP	Less than 1 -
1 — 9 12 — 7	DOWN	Less than 1 -
1 — 11 12 — 7	LEFT	Less than 1 -
1 — 12 11 — 7	RIGHT	Less than 1 -

• Changeover switch LH

Terminal No.	Inspection conditions	Standard
—	OFF	1 M- or more
1 — 14 8 — 7	UP	Less than 1 -
1 — 8 14 — 7	DOWN	Less than 1 -
1 — 10 14 — 7	LEFT	Less than 1 -
1 — 14 10 — 7	RIGHT	Less than 1 -

2. If the inspection result is not within the standard, replace the switch - door mirror.

Removal

1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE2. Remove the trim panel - front door. Door Trim > REMOVAL3. Remove the panel - ...

Installation

1. Install the switch - door mirror to the panel - power window main switch.2. Install the panel - power window main switch to the trim panel - front door.3. Install the trim panel - front door. Door ...

Other materials:

Component
1. WATER PUMP(1)Water pump pulley(10)Preheater hose(19)Engine coolant temperature sensor(2)Water pump ASSY(11)Clip(20)Gasket(3)Gasket(12)Water pipe ASSY (4)Thermostat (engine side)(13)Thermostat (CVTF cooler (with warmer feature) side)Tightening torque: N·m (kgf-m, ft-lb)(5)Gasket (engine si ...