Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection
1. SEAT COVER Check that there is no tear or fray on the cover COMPL - front backrest and the cover - front seat cushion. NOTE: • If the door side of the cover COMPL - front backrest is torn or frayed, the side airbag may not be deployed properly. In this case, replace the cover COMPL - front backrest with a new part. • If there are tears or loosening in the cover - front seat cushion, it may interfere with the proper operation of the seat cushion airbag. Replace the cover - front seat cushion with a new part. 2. CHECK ILLUMINATION OF PASSENGER’S SEAT BELT WARNING LIGHT Check that the passenger’s seat belt warning light illuminates when the passenger’s seat is occupied.
If it does not illuminate, check the seat belt warning system and the occupant detection system. • Seat belt warning system: Seat Belt Warning System • Occupant detection system: Basic Diagnostic Procedure 3. HOOK - SPRING Check the hook - spring by applying weight to the backrest assembly.
NOTE: If the appropriate stiffness is not obtained by applying weight to the backrest assembly, the hook - spring may be disengaged. If it is due to the deformation of the hook - spring, replace the hook - spring with a new part. |
Installation
1. Bring the front seat inside the vehicle.CAUTION:Be careful not to damage the body.2. Connect the connectors located under the front seat.3. Install the seat assembly.CAUTION:Tighten the slide rail ...
Disassembly
1. MANUAL SEAT (DRIVER’S SEAT)CAUTION:• Before assembling, make sure how the harnesses are routed behind the seat cushion in order to avoid misarranging. Assembling with harnesses improper ...
Other materials:
Basic diagnostic procedure procedure
STEPCHECKYESNO1.CHECK WARNING LIGHT.Check whether the airbag warning light in the combination meter is lit.Does the airbag warning light illuminate- Basic Diagnostic Procedure > PROCEDUREPerform the diagnosis according to phenomenon of the problem.2.READ DTC.1) Turn the ignition switch to OFF.2) Con ...
