Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. Bring the front seat inside the vehicle. CAUTION: Be careful not to damage the body. 2. Connect the connectors located under the front seat. 3. Install the seat assembly. CAUTION: Tighten the slide rail assembly installing bolts in the order as shown in the figure, in several steps by gradually increasing the torque until they reach the specified torque.
Tightening torque: Front seat assembly: 53 N·m (5.4 kgf-m, 39.1 ft-lb) 4. Connect the ground terminal to battery sensor. NOTE 5. Install the headrest assembly - front. |
Assembly
CAUTION:• Do not confuse the harness routing in the reverse side of the seat cushion. Assembling with harnesses improperly routed may cause the harness to get caught and short out.• If the ...
Inspection
1. SEAT COVERCheck that there is no tear or fray on the cover COMPL - front backrest and the cover - front seat cushion.NOTE:• If the door side of the cover COMPL - front backrest is torn or fra ...
Other materials:
Synthetic oil
You should use synthetic engine oil that
meets the same requirements given for
conventional engine oil. When using
synthetic oil, you must use oil of the same
classification, viscosity and grade shown
in this Owner's Manual. Refer to "Engine
oil" F12-4. Also, you must follow the oil
and filte ...
