Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection mode operation
DTC can be diagnosed by executing the Inspection Mode. After correcting the DTC, perform a necessary inspection mode and make sure that the function is resumed correctly and the DTC is recorded. 1. Perform the Clear Memory Mode. Clear Memory Mode 2. Read the DTC and check that the DTC is not displayed. Read Diagnostic Trouble Code (DTC) NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis according to DTC. After solving the DTC, repeat from step 1). 3. After the ignition switch is ON, wait for one minute or more. 4. Read the DTC and check that the DTC is not displayed. Read Diagnostic Trouble Code (DTC) NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis according to DTC. |
Electrical component location location
(1)Audio amplifier (if equipped)(3)Satellite switch(5)Audio (7-inch display) or navigation unit(2)Rearview camera (if equipped)(4)GPS antenna (if equipped)(6)Data link connector ...
List of diagnostic trouble code (dtc) list
DTCItemNoteB2240CAN COMMUNICATION (AUDIO) STUCK Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2240 CAN COMMUNICATION (AUDIO) STUCKB2241CAN COMMUNICATION Diagnostic Procedure with Diag ...
Other materials:
Installation
1. Install the leak check valve assembly to the canister.Tightening torque:8 N·m (0.8 kgf-m, 5.9 ft-lb)2. Connect the drain tube (A).CAUTION:• Check that there is no damage or dust on the quick connector. If necessary, clean the seal surface of the pipe.• Make sure that the quick ...
