Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection mode procedure
1. AUTO HEADLIGHT BEAM LEVELER SYSTEM 1. Turn the ignition switch to ON. 2. Turn on the headlight low beam. 3. Check that the beam axes move when the vehicle condition is kept for three seconds or more after the vehicle posture is changed with the vehicle stopped. 4. Read the DTC and check that the DTC is not displayed. Read Diagnostic Trouble Code (DTC) NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis according to DTC. 2. STEERING RESPONSIVE FOG LIGHT 1. Turn the ignition switch to ON. 2. Turn on the headlight low beam. 3. Turn the fog light switch to ON. 4. Check that the fog light illuminates. 5. Read the DTC and check that the DTC is not displayed. Read Diagnostic Trouble Code (DTC) NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis according to DTC. |
Electrical component location location
(1)Headlight ASSY– Headlight beam leveler actuator(4)SRF OFF switch(7)Data link connector(2)Fog light ASSY(5)SRF CMNOTE:Part label: LIGHTING CONTROL MODULE (3)Rear vehicle height sensor(6)Body int ...
List of diagnostic trouble code (dtc) list
DTCItemReferenceU0074CONTROL MODULE COMMUNICATION BUS "BODY-CAN" OFF Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC U0074 CONTROL MODULE COMMUNICATION BUS "BODY-CAN" OFFU0101LOST COMMUN ...
Other materials:
Legacy
NOTE
It may be difficult to replace the bulbs.
We recommend that you have the bulbs
replaced by your SUBARU dealer if
necessary.
Turn the shopping bag hook 90 degrees
counterclockwise and pull it out.
Turn over the trunk trim panel.
1) Rear side marker light
2) Rear turn ...
