Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. CVT MODEL 1. Install the brake pedal assembly. CAUTION: • Apply grease to the snap pin to prevent the operating rod from wear. • Replace the clevis pin with new parts, and apply thin coat of NIGTIGHT LYW No. 2 grease to the clevis pin. Tightening torque: Brake pedal: 18 N·m (1.8 kgf-m, 13.3 ft-lb) 2. Install the column assembly - steering. Steering Column > INSTALLATION 3. Install the panel - knee guard. Tightening torque: 7 N·m (0.7 kgf-m, 5.2 ft-lb) 4. Install the cover assembly - instrument panel LWR driver. 5. Connect the ground terminal to battery sensor. NOTE 6. Check that the brake light operate properly. 7. Check the brake pedal after installation. Brake Pedal > INSPECTION 2. MT MODEL NOTE: Brake pedal is integrated with the clutch pedal. For installation procedure of the brake pedal, refer to Clutch section. Clutch Pedal > INSTALLATION |
Inspection
1. Move the pad - brake pedal in a horizontal direction with a force of approx. 10 N (1 kgf, 2 lbf), and check that the pedal deflection is in the range of specifications.CAUTION:If excessive deflecti ...
Brake pipe
...
Other materials:
Dtc b2249 bluetooth module
DTC DETECTING CONDITION:• Detected when a connection between the Bluetooth module is lost (or there has already been no connection) and the connection cannot be established even after trying to reset the Bluetooth module hardware three times.• Detected when the connection with the Blueto ...
