Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Continuously variable transmission(tr690) / Converter case / Installation

1. Install the front reduction drive gear and front reduction driven gear. Front Reduction Drive Gear > INSTALLATION

2. Install the converter case cover. Converter Case Cover > INSTALLATION

3. Install the front differential assembly. Front Differential Assembly > INSTALLATION

4. Install the drive pinion shaft assembly. Drive Pinion Shaft Assembly > INSTALLATION

5. Install the primary pulley, secondary pulley and variator chain. Primary Pulley and Secondary Pulley > INSTALLATION

6. Install the transmission case. Transmission Case > REMOVAL

7. Install the forward clutch assembly. Forward Clutch Assembly > INSTALLATION

8. Install the intermediate case. Intermediate Case > INSTALLATION

9. Install the transfer reduction driven gear. Transfer Reduction Driven Gear > INSTALLATION

10. Install the transfer clutch assembly. Transfer Clutch > INSTALLATION

11. Install the rear drive shaft. Rear Drive Shaft > INSTALLATION

12. Install the extension case. Extension Case > INSTALLATION

13. Install the primary speed sensor. Primary Speed Sensor > INSTALLATION

14. Install the secondary pressure sensor. Secondary Pressure Sensor > INSTALLATION

15. Install the transmission harness. Transmission Harness > INSTALLATION

16. Install the control valve body and oil pan. Control Valve Body > INSTALLATION

17. Install the air breather hose. Air Breather Hose > INSTALLATION

18. Install the transmission assembly to the vehicle. Automatic Transmission Assembly > INSTALLATION

Adjustment

When replacing the converter case, select the following shims.• Select the shim for front reduction drive gear. Front Reduction Drive Gear > ADJUSTMENT• Select the shim for front reductio ...

Inspection

• Check for leakage of CVTF from the connection between converter case and transmission case.• Check there is no damage or cracks on the converter case. ...

Other materials:

Inspection
1. Measure the bend, and repair or replace if necessary.Camshaft bend limit:0.020 mm (0.00079 in)2. Check the journal for damage and wear. Replace if faulty.3. Check the cutout portion used for camshaft sensor for damage. Replace if faulty.4. Check the cam face condition; remove the minor faults by ...