Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. Install the socket assembly. NOTE: Align the groove of the pocket assembly - CTR with the claw of the socket assembly. 2. Install the pocket assembly - CTR. 3. Install the panel center LWR. 4. Install the cover assembly - front and the console box assembly. Tightening torque: 6.5 N·m (0.6 kgf-m, 4.8 ft-lb) 5. Install the heater control assembly. 6. Connect the ground terminal to battery sensor. NOTE |
Wiring diagram
Refer to “Front Accessory Power Supply Socket System” in the wiring diagram. Front Accessory Power Supply Socket System > WIRING DIAGRAM ...
Removal
1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE2. Remove the heater control assembly. Control Panel > REMOVAL3. Remove the cove ...
Other materials:
Driving on snowy and icy roads
WARNING
Do not use the cruise control on
slippery roads such as snowy or icy
roads. This may cause loss of
vehicle control.
CAUTION
Avoid prolonged continuous driving
in snowstorms. Snow will enter the
engine's intake system and may
hinder the airf ...
© 2017-2026 Copyright www.sulegacy.com
