Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Fuel injection (fuel systems)(h6do) / Oil flow control solenoid valve / Installation

1. INTAKE SIDE

1. Install the intake oil flow control solenoid valve, and connect the connector to the intake oil flow control solenoid valve.

Tightening torque:

6.4 N·m (0.7 kgf-m, 4.7 ft-lb)

2. Connect the ground terminal to battery sensor. NOTE

3. Install the collector cover.

2. EXHAUST SIDE

1. Install the exhaust oil flow control solenoid valve, and connect the connector to the exhaust oil flow control solenoid valve.

Tightening torque:

6.4 N·m (0.7 kgf-m, 4.7 ft-lb)

2. Install the under cover. Front Under Cover > INSTALLATION

3. Lower the vehicle.

4. Connect the ground terminal to battery sensor. NOTE

Inspection

1. Check that the oil flow control solenoid valve has no deformation, cracks or other damages.2. Measure the resistance between the oil control solenoid terminals.Terminal No.Standard1 and 27.4±0.5 - ...

Oil temperature sensor

...

Other materials:

Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the light assembly - door step.CAUTION:• Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb.• When using a flat tip screwdriver, apply protective tape or cloth and be careful not ...