Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. SEDAN MODEL 1. Install the license plate light bulb. CAUTION: Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb. 2. Install the license plate light. 3. Install the garnish - trunk. Trunk Lid Garnish > INSTALLATION Tightening torque: 4.5 N·m (0.5 kgf-m, 3.3 ft-lb) 4. Install the trim panel - trunk lid. 5. Connect the ground terminal to battery sensor. NOTE 2. OUTBACK MODEL 1. Install the license plate light bulb. CAUTION: Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb. 2. Install the license plate light. 3. Connect the ground terminal to battery sensor. NOTE |
Removal
1. SEDAN MODEL1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the trim panel - trunk lid. Trunk Room Trim > REMOVALNOTE:When removing the bulb only, remove the trim panel - trun ...
Other materials:
Removal
1. Remove the clip (A), and loosen the clamps (B) and (C) securing the air intake boot.2. Remove the air intake boot from the air cleaner case (rear) and throttle body, and move it to the left side wheel apron.3. Remove the bolts securing the throttle body to the intake manifold assembly, and tilt t ...
