Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Manual transmission and differential(6mt) / Center differential / Installation

1. Install the center differential and transfer driven gear into the transfer case as a unit. Transfer Driven Gear > INSTALLATION

2. Select the adjusting washer. Transfer Case and Extension Case Assembly > INSTALLATION

3. Install the transfer driven gear. Transfer Driven Gear > INSTALLATION

4. Install the transfer case together with the extension case assembly. Transfer Case and Extension Case Assembly > INSTALLATION

5. Install the back-up light switch and the neutral position switch. Switches and Harness > INSTALLATION

6. Install the manual transmission assembly to the vehicle. Manual Transmission Assembly > INSTALLATION

Assembly

Install the ball bearings.CAUTION:Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).NOTE:Use a new ball bearing.(A)Ball bearing ...

Inspection

1. Ball bearingReplace the ball bearing in following cases.• In case of broken or rusty ball bearings• In case of worn or damaged ball bearings• When the ball bearings fail to turn s ...

Other materials:

Electrical component location location
(1)Headlight ASSY– Headlight beam leveler actuator(4)SRF OFF switch(7)Data link connector(2)Fog light ASSY(5)SRF CMNOTE:Part label: LIGHTING CONTROL MODULE (3)Rear vehicle height sensor(6)Body integrated unit (1)Headlight relay Lo(4)Front fog light relay(7)Fuse 7.5A (SRF CM)(2)Headlight relay H ...