Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. Install the differential side retainers using ST.
2. Install the taper roller bearing outer race to the transmission case. 3. Install the front differential assembly. CAUTION: Make sure the oil seal lip is not folded.
4. Install the main shaft assembly. Main Shaft Assembly > INSTALLATION 5. Install the drive pinion shaft assembly. Drive Pinion Shaft Assembly > INSTALLATION 6. Install the transmission case. Transmission Case > INSTALLATION 7. Install the transfer case together with the extension case assembly. Transfer Case and Extension Case Assembly > INSTALLATION 8. Install the manual transmission assembly to the vehicle. Manual Transmission Assembly > INSTALLATION |
Adjustment
1. DIFFERENTIAL BEVEL PINION GEAR BACKLASH1. Disassemble the front differential assembly. Front Differential Assembly > DISASSEMBLY2. Select the adjusting washer from the table and install.Adjusting ...
Inspection
Repair or replace the differential gear in the following cases:• When the hypoid driven gear and drive pinion shaft tooth surfaces are damaged, excessively worn, or seized.• When the rolle ...
Other materials:
Dtc b1872 short in front seat cushion airbag rh (to ground)
DIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:GND short circuit failure (shorted to ground in main harness, shorted to ground in front seat side airbag RH, shorted to ground in airbag CM internal circuit)CAUTION:Before performing diagnosis, refer to “CAUTIO ...
