Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. Install the transfer drive gear. Tightening torque: 26 N·m (2.7 kgf-m, 19.2 ft-lb)
2. Install the transfer driven gear. Transfer Driven Gear > INSTALLATION 3. Select the adjusting washer. Transfer Case and Extension Case Assembly > INSTALLATION 4. Install the transfer case and the extension case assembly. Transfer Case and Extension Case Assembly > INSTALLATION 5. Install the back-up light switch and the neutral position switch. Switches and Harness > INSTALLATION 6. Install the manual transmission assembly to the vehicle. Manual Transmission Assembly > INSTALLATION |
Assembly
1. Install the needle bearing and snap ring to the transfer drive gear.2. Set the ST to the ball bearing inner race, then install the transfer drive gear.CAUTION:Do not apply a load in excess of 10 kN ...
Inspection
1. Ball bearingReplace the ball bearing in following cases.• In case of broken or rusty ball bearings• In case of worn or damaged ball bearings• When the ball bearings fail to turn s ...
Other materials:
Dtc b27a5 front internal antenna open
DTC DETECTING CONDITION:When open circuit occurs in the harness between keyless access CM and front interior antenna.TROUBLE SYMPTOM:Keyless access system does not function. (when the access key is in the front area of the passenger room)CAUTION:For replacement procedure of keyless access CM, refer ...
