Subaru Legacy BN/BS (2015-2019) Service Manual: Assembly

Subaru Legacy BN/BS (2015-2019) Service Manual / Manual transmission and differential(6mt) / Transfer drive gear / Assembly

1. Install the needle bearing and snap ring to the transfer drive gear.

2. Set the ST to the ball bearing inner race, then install the transfer drive gear.

CAUTION:

Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).

NOTE:

Use a new ball bearing.

ST 398177700

INSTALLER

3. Install the snap ring.

4. Inspect the clearance between the snap ring and the ball bearing. Transfer Drive Gear > INSPECTION

Removal

1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL2. Remove the back-up light switch and the neutral position switch. Switches and Harness > REMOVAL3 ...

Installation

1. Install the transfer drive gear.Tightening torque:26 N·m (2.7 kgf-m, 19.2 ft-lb)2. Install the transfer driven gear. Transfer Driven Gear > INSTALLATION3. Select the adjusting washer. Tran ...

Other materials:

Inspection
1. LATCHCheck if the latch operates normally.If latch deformation, abnormal wear, or unsmooth lock operation is observed, replace the lock assembly - trunk lid.2. ACTUATOR1. Check door lock operationCheck the door lock operation when battery voltage is applied between the connectors.Terminal No.Insp ...