Subaru Legacy BN/BS (2015-2019) Service Manual: Removal

Subaru Legacy BN/BS (2015-2019) Service Manual / Manual transmission and differential(6mt) / Transfer drive gear / Removal

1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL

2. Remove the back-up light switch and the neutral position switch. Switches and Harness > REMOVAL

3. Remove the transfer case together with the extension case assembly. Transfer Case and Extension Case Assembly > REMOVAL

4. Remove the extension case assembly.

5. Remove the transfer driven gear. Transfer Driven Gear > REMOVAL

6. Remove the transfer drive gear.

1. Install the needle bearing and snap ring to the transfer drive gear.2. Set the ST to the ball bearing inner race, then install the transfer drive gear.CAUTION:Do not apply a load in excess of 10 kN ...

Other materials:

Note
For procedure of each component in the power rear gate system, refer to the respective section.• Power rear gate control module (PRG CM): Power Rear Gate Control Module• Power rear gate drive unit (PRG D/U): Power Rear Gate Drive Unit• Power rear gate rod: Power Rear Gate Rod&bu ...