Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
CAUTION: • For parts which are not reusable, always use new parts. • Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground. 1. Install the trailing link. Tightening torque: Trailing link — rear sub frame assembly: 120 N·m (12.2 kgf-m, 88.5 ft-lb) Trailing link — rear axle housing: 80 N·m (8.2 kgf-m, 59.0 ft-lb) 2. Install the bracket - parking brake cable. Tightening torque: 18 N·m (1.8 kgf-m, 13.3 ft-lb) 3. Install the rear wheels and lower the vehicle. Tightening torque: 120 N·m (12.2 kgf-m, 88.5 ft-lb) |
Assembly
1. BUSHING A - TRAILING LINK1. Before assembly, inspect the following items and replace any faulty part with a new one.• Perform visual check for damage or bend on the trailing link.• Visu ...
Disassembly
1. BUSHING A - TRAILING LINKUsing the ST, push out the bushing A - trailing link.Preparation tool:ST-A: INSTALLER (899874100)ST-B: PRESS (499755602)2. BUSHING - TRAILING LINKFor the removal procedure ...
Other materials:
Removal
1. REAR GATE PANEL1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the rod - power rear gate. (Model with power rear gate) Power Rear Gate Rod > REMOVAL3. Remove the trim panel - rear gate. Rear Gate Trim > REMOVAL4. Remove the garnish assembly - rear gate. Rear Gate Garnish ...
