Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Security and locks / Key lock cylinders / Installation

1. STEERING LOCK

1. Install the key cylinder.

2. Install the key lock solenoid and immobilizer antenna assembly.

3. Install the cover assembly - column.

4. Connect the ground terminal to battery sensor. NOTE

2. FRONT DOOR

1. Install the key cylinder.

2. Install the cover - handle front outer.

CAUTION:

When installing the cover - handle front outer on driver’s side, make sure that the key cylinder shaft is correctly inserted into the latch & actuator assembly - front.

Preparation tool:

TORX® T30

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

3. TRUNK LID

1. Install the key cylinder.

2. Install the trunk lid garnish. Trunk Lid Garnish > INSTALLATION

4. GLOVE BOX LID

1. Install the key cylinder.

2. Install the pocket assembly.

Removal

1. STEERING LOCK1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE2. Remove the cover assembly - column.(1) Remove the clips, and r ...

Keyless access cm

...

Other materials:

Inspection
1. Measure the resistance between connector terminals.Preparation tool: Circuit testerTerminal No.Inspection conditionsStandard4 — 2AlwaysApprox. 0.44 -4 — 3Approx. 1.12 -4 — 1Approx. 2.92 -2. Replace the blower resistor if the inspection result is not within the standard value. ...