Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

1. SEDAN MODEL

1. Install the keyless entry control module.

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

2. Install the trim panel assembly - rear shelf. Rear Shelf Trim > INSTALLATION

3. Connect the ground terminal to battery sensor. NOTE

2. OUTBACK MODEL

1. Install the keyless entry control module.

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

2. Install the trim panel - rear apron RH. Rear Quarter Trim > INSTALLATION

3. Connect the ground terminal to battery sensor. NOTE

Removal
1. SEDAN MODEL1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the trim panel assembly - rear shelf. Rear Shelf Trim > REMOVAL3. Remove the keyless entry control module.(1) Disco ...

Keyless entry system
...

Other materials:

Installation
1. CAM CARRIER RH1. Insert the steel rods into ST, and set the engine so that the camshaft RH is facing up.CAUTION:• If the engine is standing on one side without inserting the steel rod into ST, engine may lose balance and fall down. Be sure to insert the steel rod into ST to extend the lengt ...

© 2017-2026 Copyright www.sulegacy.com