Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Glass windows mirrors / Rearview mirror / Installation

CAUTION:

When tightening the mounting TORX® screw, be sure to observe the tightening torque. Otherwise, the mount may be damaged in over-torque conditions.

1. NORMAL MIRROR TYPE

1. Slide the mirror assembly - inner rearview to the mirror mount to install.

NOTE:

If the mirror mounting is damaged, replace the windshield glass.

Tightening torque:

Refer to “COMPONENT” of “General Description”. General Description > COMPONENT

2. HOME LINK TYPE

1. Slide the mirror assembly - inner rearview to the mirror mount to install.

NOTE:

If the mirror mounting is damaged, replace the windshield glass.

Tightening torque:

Refer to “COMPONENT” of “General Description”. General Description > COMPONENT

2. Attach the harness cover (a).

3. Connect the ground terminal to battery sensor. NOTE

4. Perform calibration and zone setting of the rearview mirror. (With compass)

• CALIBRATION Rearview Mirror > ADJUSTMENT

• ZONE SETTING Rearview Mirror > ADJUSTMENT

Adjustment

CAUTION:• When the rearview mirror with compass and home link is removed or replaced, perform calibration and zone setting by following the procedures below.• The zone setting of the vehic ...

Inspection

Check the mirror and mirror mount for damage. ...

Other materials:

Installation
1. SEDAN MODELCAUTION:If the hook - rear seat is disconnected from the vehicle body, make sure to replace the hook - rear seat with a new part to prevent the decline of the fixed force of the seat.1. Install the trim panel - rear pillar UPR.2. Install the side pad assembly - backrest.Tightening torq ...