Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. Install the cushion rubber and the rear exhaust cover to the vehicle body. Tightening torque: 10 N·m (1.0 kgf-m, 7.4 ft-lb) 2. Install the muffler to the cushion rubber. 3. Install the bolts and self-locking nuts securing the rear exhaust pipe to the muffler. NOTE: • Use a new gasket and self-locking nut. • After assembling, degrease the lubricant which was applied to the cushion rubber while removing/installing. Tightening torque: 48 N·m (4.9 kgf-m, 35.4 ft-lb) 4. Lower the vehicle. |
Inspection
1. Check the connections and welded parts for exhaust leaks.2. Make sure there are no holes or rusting.3. Check the cushion rubber for wear or crack. ...
Other materials:
Assembly
1. Using the ST, install the taper roller bearing (transfer case side).CAUTION:Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).NOTE:Be careful when handling because the taper roller bearing and the outer race are used as a set.ST 927640000INSTALLER(A)Taper roller bearing ( ...
