Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. Apply a coat of spray type lubricant to the mating area of cushion rubber. 2. Install the rear exhaust pipe to cushion rubber. NOTE: After assembling, degrease the lubricant which was applied to the cushion rubber while removing/installing. 3. Install the bolts and self-locking nuts which secure the muffler to the rear exhaust pipe. NOTE: Use a new gasket and self-locking nut. Tightening torque: 48 N·m (4.9 kgf-m, 35.4 ft-lb) 4. Install the bolts, springs and nuts securing the front exhaust pipe assembly to the rear exhaust pipe. NOTE: Use a new gasket. Tightening torque: 18 N·m (1.8 kgf-m, 13.3 ft-lb) 5. Lower the vehicle. |
Inspection
1. Check the connections and welded parts for exhaust leaks.2. Make sure there are no holes or rusting.3. Check the cushion rubber for wear or crack. ...
Seats
...
Other materials:
Removal
Refer to “DISASSEMBLY” for removal procedures of scalp cap and mirror face. Outer Mirror Assembly > DISASSEMBLY1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE2. Remove the trim panel - front door. Door Trim > REMOV ...
