Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. SEAT HEATER MODULE - FRONT 1. Affix the seat heater module - front to the pad assembly. CAUTION: • If the cover - front cushion is removed, make sure to replace the hang wire on the cover - front cushion side with a new wire. • When replacing the seat cover, be careful not to damage the occupant detection sensor while installing the hog ring. • When removing or replacing the seat cover, perform “Occupant Detection System Inspection” after installing the seat to check if the occupant detection system operates normally. PRE-DELIVERY INSPECTION (PDI) PROCEDURE • If the seat heater module is removed, replace the seat cushion pad & frame assembly with a new part. • If the seat heater module is reused, remove the polyurethane section from the reverse side completely. Double-sided tape: NITTO DENKO 501L or equivalent 2. Assemble the front seat. Front Seat > ASSEMBLY 3. Install the front seat. Tightening torque: 53 N·m (5.4 kgf-m, 39.1 ft-lb) 2. SEAT HEATER SWITCH - FRONT Install the heater control assembly. Control Panel > INSTALLATION 3. SEAT HEATER MODULE - REAR 1. Affix the seat heater module - rear to the pad assembly. Double-sided tape: NITTO DENKO 501L or equivalent 2. Assemble the rear seat. Rear Seat > ASSEMBLY 3. Install the rear seat. Rear Seat > INSTALLATION 4. SEAT HEATER SWITCH - REAR 1. Install the seat heater switch - rear. 2. Install the end cover - console box. 3. Install the battery sensor to the ground terminal. NOTE 5. SEAT HEATER UNIT - REAR Sedan model 1. Install the seat heater module - rear. Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 2. Install the trim panel - rear pillar UPR RH. Rear Quarter Trim > INSTALLATION OUTBACK model 1. Install the seat heater module - rear. Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 2. Install the trim panel - rear apron RH. Rear Quarter Trim > INSTALLATION 6. SEAT HEATER RELAY AND FUSE 1. Install the seat heater relay & fuse. Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 2. Install the cover assembly - instrument panel LWR driver. 3. Connect the ground terminal to battery sensor. NOTE |
Inspection
1. WIRING DIAGRAMRefer to “Seat Heater System” in the wiring diagram.• Front: Seat Heater System > WIRING DIAGRAM• Rear: Seat Heater System > WIRING DIAGRAM2. DIAGNOSTIC CHAR ...
Other materials:
Installation
1. Install the socket assembly.NOTE:Align the groove of the console box assembly or the trim panel - rear apron LH with the claw of the socket assembly.2. Install the cover assembly - front console box assembly. (Console type)Tightening torque:6.5 N·m (0.6 kgf-m, 4.8 ft-lb)3. Install the trim ...
