Subaru Legacy BN/BS (2015-2019) Service Manual: Intake and exhaust valve specification

Subaru Legacy BN/BS (2015-2019) Service Manual / Mechanical(h6do) / Intake and exhaust valve specification

Refer to “Cylinder Head” for removal and installation procedures of the intake and exhaust valves. Cylinder Head > REMOVAL Cylinder Head > INSTALLATION

Ignition timing inspection

CAUTION:After warming-up, engine becomes very hot. Be careful not to burn yourself at measurement.1. METHOD WITH SUBARU SELECT MONITOR1. Before checking the ignition timing, check the following item:( ...

Intake manifold vacuum inspection

1. Warm up the engine.2. Remove the collector cover.(1) Carefully pull up the rear of collector cover at two positions (A).(2) Carefully pull up the front of collector cover at two positions (B) while ...

Other materials:

Inspection
1. CAMSHAFT POSITION SENSOR1. Disconnect the ground terminal from battery sensor. NOTE2. Prepare an oscilloscope.3. While pressing the section (A) shown in the figure, move the lock lever (B) in the direction of the arrow to disconnect the connectors from the ECM in numerical order as shown in the ...