Subaru Legacy BN/BS (2015-2019) Service Manual: Main relay

Installation

1. Install the knock sensor to the cylinder block, and connect the connector (A) to the knock sensor.Tightening torque:25 N·m (2.5 kgf-m, 18.4 ft-lb)NOTE:The knock sensor should be installed so ...

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the main relay from main fuse box. ...

Other materials:

Dtc c2532 control module peripheral circuit
DTC DETECTING CONDITION:• When torque sensor peripheral circuit malfunction inside the power steering control module is detected after assist starts with 500 rpm engine speed reception.• When storage medium IC malfunction inside the power steering control module is detected at initial ch ...