Subaru Legacy BN/BS (2015-2019) Service Manual: Malfunction indicator light does not come on

Subaru Legacy BN/BS (2015-2019) Service Manual / Engine (diagnostics)(h4do) / Malfunction indicator light / Malfunction indicator light does not come on

TROUBLE SYMPTOM:

When the ignition switch is turned to ON (engine OFF), malfunction indicator light does not illuminate.

STEP	CHECK	YES	NO
1.CHECK DTC.	Is DTC of LAN system displayed- Read Diagnostic Trouble Code (DTC) > OPERATION	Check the appropriate DTC using the “List of Diagnostic Trouble Code (DTC)”. List of Diagnostic Trouble Code (DTC)	Replace the meter case assembly of combination meter. Combination Meter

Procedure

1. Activation of malfunction indicator light Malfunction Indicator Light > ACTIVATION OF MALFUNCTION INDICATOR LIGHT↓2. Malfunction indicator light does not come on Malfunction Indicator Light ...

Activation of malfunction indicator light

1. When the ignition switch is turned to ON (engine OFF), the malfunction indicator light (A) in the combination meter illuminates.NOTE:If the malfunction indicator light does not illuminate, perform ...

Other materials:

Dtc b2781 steering lock cm control circuit
DTC DETECTING CONDITION:• When malfunction is detected in lock/unlock position detection sensor.• When the open or short circuit in the steering lock motor drive circuit is detected.TROUBLE SYMPTOM:• The steering lock cannot be released.• Engine will not start.CAUTION:For rep ...