Subaru Legacy BN/BS (2015-2019) Service Manual: Malfunction indicator light does not come on

Subaru Legacy BN/BS (2015-2019) Service Manual / Engine (diagnostics)(h6do) / Malfunction indicator light / Malfunction indicator light does not come on

TROUBLE SYMPTOM:

When the ignition switch is turned to ON (engine OFF), malfunction indicator light does not illuminate.

STEP	CHECK	YES	NO
1.CHECK DTC.	Is DTC of LAN system displayed- Read Diagnostic Trouble Code (DTC) > OPERATION	Check the appropriate DTC using the “List of Diagnostic Trouble Code (DTC)”. List of Diagnostic Trouble Code (DTC)	Replace the meter case assembly of combination meter. Combination Meter

Malfunction indicator light does not go off

TROUBLE SYMPTOM:Although malfunction indicator light comes on when the engine runs, DTC is not shown on the Subaru Select Monitor or general scan tool display.STEPCHECKYESNO1.CHECK DTC.Is DTC of engin ...

Activation of malfunction indicator light

1. When the ignition switch is turned to ON (engine OFF), the malfunction indicator light (A) in the combination meter illuminates.NOTE:If the malfunction indicator light does not illuminate, perform ...

Other materials:

Inspection
1. Measure the resistance between connector terminals.Preparation tool: Circuit testerTerminal No.Inspection conditionsStandard4 — 2AlwaysApprox. 0.44 -4 — 3Approx. 1.12 -4 — 1Approx. 2.92 -2. Replace the blower resistor if the inspection result is not within the standard value. ...