Subaru Legacy BN/BS (2015-2019) Service Manual: Malfunction indicator light does not go off

Subaru Legacy BN/BS (2015-2019) Service Manual / Engine (diagnostics)(h6do) / Malfunction indicator light / Malfunction indicator light does not go off

TROUBLE SYMPTOM:

Although malfunction indicator light comes on when the engine runs, DTC is not shown on the Subaru Select Monitor or general scan tool display.

STEP	CHECK	YES	NO
1.CHECK DTC.	Is DTC of engine or LAN system displayed- Read Diagnostic Trouble Code (DTC) > OPERATION	Check the appropriate DTC using the “List of Diagnostic Trouble Code (DTC)”. List of Diagnostic Trouble Code (DTC) List of Diagnostic Trouble Code (DTC)	Malfunction Indicator Light > MALFUNCTION INDICATOR LIGHT DOES NOT GO OFF
2.CHECK COMBINATION METER. Perform the self-diagnosis for combination meter system. Combination Meter System > OPERATION	Does the malfunction indicator light illuminate and go off normally-	Replace the ECM. Engine Control Module (ECM)	Replace the meter case assembly of combination meter. Combination Meter

Malfunction indicator light does not blink

DIAGNOSIS:• The malfunction indicator light circuit is open or shorted.• The delivery (test) mode fuse circuit is open.TROUBLE SYMPTOM:Malfunction indicator light does not blink during Ins ...

Malfunction indicator light does not come on

TROUBLE SYMPTOM:When the ignition switch is turned to ON (engine OFF), malfunction indicator light does not illuminate.STEPCHECKYESNO1.CHECK DTC.Is DTC of LAN system displayed- Read Diagnostic Troubl ...

Other materials:

Installation
1. Clean the mating surface of oil pan and transmission case.2. Install the O-rings.NOTE:• Use new O-rings.• Apply CVTF to the O-rings.3. Install the oil strainer.Tightening torque:9 N·m (0.9 kgf-m, 6.6 ft-lb)4. Clean the magnet.5. Attach the magnet at the specified position of th ...