Subaru Legacy BN/BS (2015-2019) Owners Manual: Odometer
This meter displays the odometer when the ignition switch is in the "ON" position. The odometer shows the total distance that the vehicle has been driven.
If you press the trip reset switch when the ignition switch is in the "LOCK"/"OFF" or "ACC" position, the odometer/trip meter will light up. If you do not press the trip reset switch within 10 seconds of illumination of the odometer/trip meter, the odometer/ trip meter will turn off. Also, if you open and close the driver's door within 10 seconds of illumination of the odometer/trip meter, the odometer/trip meter will turn off. |
Canceling the function for meter/gauge needle
movement upon turning on the ignition
switch
It is possible to activate or deactivate the
movement of the meter needles and
gauge needles that takes place when the
ignition switch is turned to the "ON"
position. For details, perform the proc ...
Double trip meter
This meter displays the two trip meters
when the ignition switch is in the "ON"
position.
The trip meter shows the distance that the
vehicle has been driven since you last set
it to zero.
...
Other materials:
Installation
1. Clean the crankshaft thread using compressed air.2. Install the crank pulley.3. Apply engine oil to the crank pulley bolt seat and thread.4. Use the ST to lock the crank pulley, and tighten the crank pulley bolt.NOTE:After tightening, if engine oil is spilt onto the crank pulley bolt or the crank ...
