Subaru Legacy BN/BS (2015-2019) Owners Manual: Roof rails with integrated crossbars (Outback - if equipped)

Subaru Legacy BN/BS (2015-2019) Owners Manual / Driving tips / Loading your vehicle / Roof rails with integrated crossbars (Outback - if equipped)

Roof rails with integrated crossbars (Outback - if equipped)

1) Integrated crossbars

CAUTION

For cargo carrying purposes, the bars must be used as crossbars and be used together with the genuine SUBARU carrying attachment.
The bars must never be used alone to carry cargo.
Otherwise, damage to the roof or paint or a dangerous road hazard due to loss of cargo could result.
When using the bars as crossbars, make sure that the total weight of the carrying attachment and cargo does not exceed the 150 lbs (67.5 kg). Overloading may cause damage to the vehicle and create a safety hazard.

The bars can be used as crossbars.

Cargo can be carried after setting the bars as crossbars and installing the genuine SUBARU carrying attachment.

When you carry cargo on the roof using the crossbars and a carrying attachment, never exceed the maximum load limit explained in the following. You should also be careful that your vehicle does not exceed the Gross Vehicle Weight Rating (GVWR) and front and rear Gross Axle Weight Rating (GAWR). For information on loading cargo into or onto your vehicle, refer to "Loading your vehicle" . The maximum load limit of the cargo and carrying attachment must not exceed the allowable load limit described in the Owner's Manual of a genuine SUBARU carrying attachment. Place the heaviest load at the bottom, nearest the roof, and evenly distribute the cargo. Always properly secure all cargo.

Roof rack (Outback - if equipped)

CAUTION For cargo carrying purposes, the roof rail must be used together with the roof rack. The roof rail must never be used alone to carry cargo. Otherwise, dama ...

Installing carrying attachments on the crossbars

When installing any carrying attachment such as a bike carrier, ski carrier, kayak carrier, cargo basket, etc. on the crossbars, follow the manufacturer's instructions and make sure that the attac ...

Other materials:

Assembly
1. Apply CVTF to the seal of reverse brake piston and install it to intermediate case.2. Install the return spring.3. Set the spring retainer and snap ring.(A)Snap ring(B)Spring retainer4. Set the ST1, ST2 and ST3 to intermediate case.ST1 18762AA001COMPRESSOR SPECIAL TOOLST2 18763AA000COMPRESS ...