Subaru Legacy Service Manual: Operation
1. On «Start» display, select «Diagnosis». 2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed». 3. On «Main Menu» display, select «Each System». 4. On «Select System» display, select «Power Rear Gate» and then select «Enter». 5. On «Select Function» display, select «Data Monitor». NOTE: • For detailed operation procedures, refer to “Application help”. • Communication with PRG CM and Subaru Select Monitor takes time. It takes time to show all the items, and the status cannot be reflected on the display. Therefore, select items only that need to be checked or up to two to three items, when checking the status. (When displaying selected items only, place a check mark for the item to be displayed and press the “Select” button.) |
List
Item NameDescriptionStandardNote+POWER BPower supply voltage value9 — 16 V — + BPRG CM power supply voltage value9 — 16 V — IGN SWIgnition switch statusON: IGN ONOFF: IGN OFF — Memory stop S ...
Other materials:
Dtc p2012 tgv control circuit low bank 2
DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE TYPE FB (WITHOUT PUSH BUTTON ST ...
