Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Owners Manual: Outback

Subaru Legacy BN/BS (2015-2019) Owners Manual / Maintenance and service / Replacing bulbs / Rear combination lights / Outback

Outback

  1. Undo the clips. For the method to undo the clips, refer to "Type C clips" F11-6.
  2.  Remove the cover.

Outback

  1. Remove the upper and lower screws.

Outback

  1. Slide the rear combination light assembly straight rearward and remove it from the vehicle.

Outback

1) Rear turn signal light
2) Rear side marker light

  1.  Remove the bulb holder from the rear combination light assembly by turning it counterclockwise.
  2.  Pull the bulb out of the bulb holder and replace it with a new one.
  3.  Set the bulb holder into the rear combination light assembly and turn it clockwise until it locks.

Outback

  1. Reinstall the rear combination light assembly by sliding the two-pronged part of the combination light assembly securely to each holder of the vehicle side.

Outback

  1. Tighten the upper and lower screws.
  2.  Reinstall the side cover.
Legacy
NOTE It may be difficult to replace the bulbs. We recommend that you have the bulbs replaced by your SUBARU dealer if necessary. Turn the shopping bag hook 90 degrees counterclockwise an ...

Backup light
...

Other materials:

Basic diagnostic procedure procedure
STEPCHECKYESNO1.CHECK WARNING LIGHT.Check whether the airbag warning light in the combination meter is lit.Does the airbag warning light illuminate- Basic Diagnostic Procedure > PROCEDUREPerform the diagnosis according to phenomenon of the problem.2.READ DTC.1) Turn the ignition switch to OFF.2) Con ...

© 2017-2026 Copyright www.sulegacy.com