Subaru Legacy BN/BS (2015-2019) Owners Manual: Outback

Subaru Legacy BN/BS (2015-2019) Owners Manual / Maintenance and service / Replacing bulbs / License plate light / Outback

Outback

The license plate light must be pushed inwards, and then pulled out to be removed.

Outback

Turn the bulb socket counterclockwise and pull out the socket.
Pull the bulb out of the socket.
Install a new bulb.
Reinstall the bulb socket and the license plate light cover.

Legacy

NOTE It may be difficult to replace the bulbs. We recommend that you have the bulbs replaced by your SUBARU dealer if necessary. Open the trunk. Remove the trunk trim lining by remov ...

Dome light

Remove the lens by prying the edge of the lens with a flat-head screwdriver. Turn the bulb until the flat surfaces at its ends are aligned vertically. Pull the bulb straight d ...

Other materials:

Installation
CAUTION:• Be careful not to damage the sensor.• Do not apply excessive force to the sensor harness.1. Install the rear ABS wheel speed sensor.NOTE:Check the identification (mark) on the harness to make sure there is no warpage. General Description > SPECIFICATIONTightening torque:Rear A ...