Subaru Legacy BN/BS (2015-2019) Service Manual: Power rear gate control module

Installation

1. Install the power rear gate buzzer.2. Install the trim panel - rear gate.3. Connect the ground terminal to battery sensor. NOTE ...

Removal

1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE2. Remove the trim panel - rear apron LH. Rear Quarter Trim > REMOVAL3. Remove t ...

Other materials:

Removal
1. FRONT CUSHION RUBBER AND ENGINE MOUNTING BRACKET1. Fully open the front hood. NOTE2. Disconnect the ground terminal from battery sensor. NOTE3. Remove the air intake duct. Air Intake Duct > REMOVAL4. Remove the clip (A), and loosen the clamps (B) and (C) securing the air intake boot.5. Remove ...