Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Power rear gate system / Power rear gate control module / Installation

1. Install the power rear gate control module (PRG CM).

NOTE:

Connect the connectors in reverse order of removal.

2. Install the trim panel - rear apron LH.

3. Connect the ground terminal to battery sensor. NOTE

Removal

1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE2. Remove the trim panel - rear apron LH. Rear Quarter Trim > REMOVAL3. Remove t ...

Power rear gate drive unit

...

Other materials:

Dtc p0974 shift solenoid "a" control circuit high
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:Gear is not changed. (No up-shift)1. ENGINE TYPE FBWIRING DIAGRAM:CVT control system CVT Control System > WIRING DIAGRAMSTEPCHECKYESNO1.CHECK HARNESS.CAUTION:Start work after ATF cools down.1) Turn the ignition switch to OFF.2) ...