Subaru Legacy BN/BS (2015-2019) Service Manual: Power rear gate drive unit

Installation

1. Install the power rear gate control module (PRG CM).NOTE:Connect the connectors in reverse order of removal.2. Install the trim panel - rear apron LH.3. Connect the ground terminal to battery senso ...

Removal

1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE2. Remove the rod - power rear gate. Power Rear Gate Rod > REMOVAL3. Remove the ...

Other materials:

Active test operation
CAUTION:• Be sure to perform the active test while the engine is not running.• After executing the active test, execute the Clear Memory Mode.1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the vehicle information and select «Confirmed».3. On « ...