Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Power rear gate system / Power rear gate drive unit / Installation

1. Install the power rear gate drive unit (PRG D/U).

Tightening torque:

25 N·m (2.5 kgf-m, 18.4 ft-lb)

2. Install the trim panel - rear apron LH and trim panel - rear quarter trim UPR rear LH.

3. Install the rod - power rear gate. Power Rear Gate Rod > INSTALLATION

4. Connect the ground terminal to battery sensor. NOTE

Removal

1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE2. Remove the rod - power rear gate. Power Rear Gate Rod > REMOVAL3. Remove the ...

Power rear gate driver’s switch

...

Other materials:

Removal
CAUTION:• Refer to “CAUTION” of “General Description” before handling the airbag system components. General Description > CAUTION• If the hook - rear seat is disconnected from the vehicle body, make sure to replace the hook - rear seat with a new part to prevent ...